An open office floored wall to wall in wide reclaimed teak planks under a teak slat ceiling
The floors

Six floors.
One wood.

Engineered planks from 3½″ to 10″ wide, all three layers in reclaimed teak. Each board below is a real studio photograph, shown at its true width against the others.

Reclaimed teak, with small teak plugs and marks from its first life.

Build your floor

Pick a width.
Pick a tone.

Every width in every tone, rendered from photos of the real floor. The card in the corner is a real studio photograph, and since no two reclaimed boards are alike, a sample is the truest preview.

Width
Tone
Inside every plank

Three layers.
All reclaimed teak.

Most engineered floors are a face of wood glued over plywood. Ours is reclaimed teak in every layer, for ultimate stability.

Where it comes from

From beam to board.

A floor needs length and width, so ours comes from the beams of old buildings: long enough for a board, wide enough to give a face.

  1. 01

    Old, long beams

    Teak beams and posts that held up homes, warehouses and bridges for 100 to 500 years.

  2. 02

    The outside becomes patina

    The weathered outer face is sliced off whole and kept: our single- and multi-face patina.

  3. 03

    The inside becomes smooth and wire brush

    Inside, the old-growth teak is clean and dense, ready to be sanded smooth or wire-brushed.

  4. 04

    The offcuts become the layers beneath

    What is left is cut into the core and the backing. It is the same teak, so every layer moves at the same rate, and nothing goes to waste.

Kiln-dried6%

Every board is kiln-dried to 6% moisture before it is milled.

One teak3 layers

The face, the core and the backing all come from the same beams.

Zero Trees Harmed

No tree is cut for our floors, and the offcuts go into the layers beneath.

At home

Floors in finished rooms.

All projects
Samples

Hold it before
you choose.

Order a $5 sample of any width, tone and texture. Our team quotes your project from there.